Prices are subject to change without notice. All guns will get a face to face estimate.
SERVICE CHARGES
Per Man Hour $45
Per Man & Machine Hour $60
Written appraisals, cost estimates $30 (per 4 guns)
CLEAN & OIL CUSTOMER GUN
Consisting of completely stripping gun, cleaning all parts, checking for wear, making suggestions to a customer of services needed to put in A-1 condition
$50 and up , up charges for break opens, excessive dirty guns etc
METAL FINISHING
OXYNATE 7TM REBLUING
Abrasive / bead blast / wire wheel (matte) finish Deluxe Finish: $95
Same as above followed with #240 and #400 grit polish with all screw holes and corners protected and square
Handgun $140
Rifle/shotgun Master Finish: $135
Same as Deluxe Finish with all polishing marks removed, no ripples, and finished with #555 polish to a mirror finish
Handgun $175
Rifle/shotgun $160
SLOW RUST BLUING / BROWING $200
PARKERIZING $100
SIGHT WORK
SIGHT IN CUSTOMER GUN - Does not include cost of ammo, targets, etc. $50
BORE SIGHTING CUSTOMER GUN $20
PATTERN SHOTGUN - Does not include cost of ammo, targets, etc. $50
DRILL AND TAP BARREL OR RECEIVER FOR SIGHTS
Per hole $20
INSTALL INSERT IN PISTOL SIGHT $30
INSTALL FRONT OR MID-RIB BEAD ON SHOTGUN (Plus cost of sight) $20
INSTALL RECEIVER SIGHTS
Gun drilled and tapped $20
SCOPE MOUNTING
Gun drilled and tapped $30
GENERAL BARREL, ACTION & RIFLE WORK
CHECK HEADSPACE $35
MAKE CHAMBER CAST $50
REMOVE STUCK FIRED CASE FROM CHAMBER $45
REMOVE LIVE ROUND FROM CHAMBER Hourly
REMOVE OBSTRUCTION FROM BORE Hourly
REMOVE FOULING FROM BARREL Hourly
INSTALL LINER IN BARREL - Not including cost of liner or bluing Hourly
CUT AND CROWN BARREL
Rifles and Shotguns / Handguns $75
TRIGGERS (INSTALLATION OR ADJUSTMENT) Not including cost of trigger. (hourly for some jobs) $40
INSTALL MUZZLE BRAKE $50
SHOTGUN WORK
LONG FORCING CONE
Non-plated bores, per barrel $40
Plated bores, per barrel $50
RAISING DENT IN BARREL
Not including bluing $30
POLISH CHAMBER/BORE $35
BACK-BORING (non plated barrels) Hourly
OPEN / MODIFY CHOKE $40
PORT BARREL - PER BARREL $75
STOCK WORK
WOOD FINISHING (Does not include any shaping)
Hunter Finish
Unfilled oil or lacquer finish on average stock $90
Same finish but on a complicated stock $110
Gunsmith Finish
Filled, rubbed oil finish on average stock $135
Same finish but on a complicated stock $150
Spray Finish
Lacquer or polyurethane $95
GLASS BEDDING BARREL & ACTION $60
INSTALL RECOIL PAD - Labor only + pad
INSTALL ADJUSTABLE BUTT PLATE - Labor only
FIT, BED AND FINISH FIBERGLASS STOCK BLANK $175
PREFINISHED SYNTHETIC STOCK Fit and install barreled action $60
INSTALL ADJUSTABLE COMB HARDWARE $120